Mounting the engine is one of the more difficult parts of playing My Summer Car.
In addition, the chapter showsthe final installation of the engineand its other necessary components.
Building theEngine and Gearboxis covered on a separate page of the tutorial.
Go there first and return to the current page having the engine ready.
How to prepare to roll out the engine?
Installation of the listed parts is described below.
CLUTCH MASTER CYLINDER should be placed next to it.
Again, attach it with two 8 mm bolts and one 9 mm.
Brake Lining
BRAKE LINING goes to the rear wall of the engine compartment.
you better find seven bolts andone on each wheel.
All have a 7 mm size.
How to use a jack to put the engine in the body?
To implement the engine, you will needthe blue mini crane found in the garage.
Prepare in advance the size 10 wrench.
When you reach the correct position, you will see two green screws.
Tighten them with the size 10 wrench.
Now, raise the engine so it canhang over the compartment in the car.
Move it above the body and slowly lower.
While you are lowering the engine, look for the green bolts.
Two are in the front, in the corner of the sled, and one in the back.
All of them are 11mm size.
The rear screw will be in the middle.
you’re able to take it to the garage so it doesn’t get in the way.
Electrics, Air Filter and Exhaust Pipe
Install ELECTRICS in the engine compartment using two 8mm nuts.
Insert the AIRFILTER on the top of the engine with two 6mm bolts.
Screw it with two 7mm bolts to the engine and one 7mm bolt from the rear.
Radiator and Radiator Hoses
Then, set up the RADIATOR in front of the engine compartment.
Secure it with four 7mm bolts.
RADIATOR HOSE 1, 2, 3 (this hose has three parts) goes from the radiator.
Install them in that order without using any screws.
Start with the radiator itself.
Inspection Cover
set up the clutch wires from the rear.
Two 7mm bolts are near the cylinder, and next to the flywheel and gearbox.
Cover the clutch with INSPECTION COVER, attached with four 7mm bolts.
Half Shaft, Gear Linkage and Gear Stick
The next elements require easy access to the chassis.
you’re free to easily push it from the side to adjust the direction.
Tighten both HALF SHAFTSfor the gearbox with three 9mm bolts.
GEAR LINKAGES are attached to the gearbox with three 5mm bolts.
Look for green nuts and use the right wrench.
You probably know where GEAR STICK goes.
Three 6 mm bolts in the cabine.
Handbrake
The placement for the HANDBRAKE is also obvious.
Four 8mm bolts are inside.
One 5mm is under the car, in the rear, next to the left wheel.
Fuel Tank, Muffler and Fuel Tank Pipe
The FUEL TANK goes under the trunk.
Look for seven 11mm bolts and one 12mm.
Install MUFFLER near the fuel tank with one 7mm bolt.
Connect the fuel filler with the FUEL TANK PIPE.
In about this location.
How to finish the work?
The dirtiest work is done.
Time to get the car out of the garage!
We now recommend going to the following pages:Battery and electrical system,Body and interiorandFirst engine start.
This site is not associated with and/or endorsed by the Amistech Games or Amistech Games.
All logos and images are copyrighted by their respective owners.
