The station schematics will open.
Enter the UN-01 module.
Hold R and press FALSE.
Do the same in the EAS-03 module.
You will find yourself in module EAS-09.
Use SPHERE to move to EAS-11.
punch the circle highlighted by the red circle.
punch it again - this time with the right mouse button.
You will combine damaged files.
Once the files are connected with red lines, use space bar to go back to SPHERE.
Find a gadget called EAS AIRLOCK CONTROL on the wall and connect to it.
select Close in the upper right corner to end the hatch of the EAS-11 module.
Go outside and find the Panel highlighted in blue called EAS-03 HATCH CLAMPS.
It is located on module EAS-03.
The exterior modules are numbered so you might’t get lost.
Connect to the panel.
The numbers 2, 4, and 8 will be red.
press 2, then on START CLAMP RESET.
Keep holding S until the circle gets close to the numbers.
Keep holding S and keep pressing W until the clamp at the red number moves out.
Release W and then S. Do the same with the remaining clamps marked in red.
Drive up to the SOLAR ARRAY located behind module EAS-07 and inform Emma about the damage.
Find the detached station module (near EAS-10) and drive inside.
The entrance will be narrow, so be careful not to damage yourself.
There is a laptop there.
Connect to it and recover a message called IN MY SUIT, HEADING OUT.
Then, find the damaged item called RU-07.
It will flash in red color if you hold R. Drive towards it and inform Emma.
Go back to the station, to module EAS-11.
Connect to the panel to get to exit the hatch.
Exit the panel, press the space bar and connect to the cameras in the EAS-03 module.
Connect to control light to bring up the hatch behind Emma.
Go to SCHEMATIC SYSTEM while holding down the right mouse button.
press the corresponding square and use AWSD to grab the diagram (L3).
kick off the hatch to the central module.
This site is not associated with and/or endorsed by the Devolver Digital or No Code.
All logos and images are copyrighted by their respective owners.
